Recent content by cherbi7

1986 rx7 s4 motor s5 intake. Header and complete exhaust all the way back. I just got my car put together trying to make an autocross this weekend for shake down. I had to replace the fuel pump, thats all stock except I ran new steel lines 3/8 to the front. I had a pressure gauge on it when...

I have a 1986 Rx-7. I purchased an auto meter tach that was used on an Rx-7 but have no idea which wires go where... I have searched autometers website and cannot find any information on the wiring for this. Can anybody tell me which wire goes where. I have a red, green, black, and white wire...

I have purchased a baffle plate for between the motor and pan. Is there anything I need to know about when I install or extras I should do while there? I know there is some sort of oil pressure regulator should I upgrade this or can I shim it out or change a spring for more pressure? Thanks

I am not too sure about what tire I should use and unfortunately I do not have the budget to spend a ton of money on tires. Has anyone tried the Nitto NT-01 225/45ZR-15 87Z BLK? (approx. $140) Or are there any suggestions on other cheapish tires I should try out.I am just trying to get some seat...

1986 Rx-7 I went to install the Lower A-arm busings which I bought from MMR-Direct. They seem to be very tight and I do not want to force them on and crack them. My question is should I heat them up? (maybe put them in boiling water to soften them)Or will they flex enough when I press them on? I...

1986 Rx-7 ITS I am nearing the finish of my build and have a couple of loose ends to tie up. The biggest issue is that I am looking to get a set of Delrin bushings but I am having a hard time finding complete kits. What is a good source for the bushings? What do I really need to get? Do I even...

1986 rx-7 Can you remove the cold start thing on the motor? I have searched and cannot find anything on this...(is this considered emissions stuff?) If I can I know I have to plug some vaccuum lines and a port in the top of the motor and the intake. Can anyone run me through the steps? 2. Can I...

I am new to road racing and am lost on what to do with the suspension. I am on a strict budget and cannot spend a lot of money. I have been looking at this stuff and was wondering am I on the right track or not? 0000-04-7201-AC C KIT, STRUT TUBE 1 RX-7 1986-91 $333.00 0000-04-7250 C...

Does anybody know if you can remove the air pump without damaging the engine? I heard that the air pump helps oil the engine. I have looked all over the place and can't seem to get a straight anwer.