Recent content by GT240sx

  1. G

    fuel pressure variation

    Does anyone here notice a 2-3psi fuel pressure drop between fuel pressure at idle and fuel pressure at full throttle? fuel pressure is the main variable I change when tuning the car and I have been trying to get fuel pressure to stay as constant as possible. Is it reasonable to expect fuel...
  2. G

    Put your 82-85 Supra on a diet

    I just checked the 2007 GCR and the new weight for the Supra is 2750 instead of 2890! That would be great if I new where to loose the weight! Isn't the typical rule of thumb 0.1 seconds per 10lbs?
  3. G

    Ballast rule change

    Rule: Ballast may be used. All ballast shall be located in the front passenger footwell/seating area, aft of the firewall and any footwell angle, and forward of the aft-edge of the forward-most passenger door opening, unless otherwsie specified the vehicle’s spec line.OEM front passenger seat...
  4. G

    FYI Engine and Drivetrain parts for sale

    I posted this in the classifieds section, put just wanted to let you guys know. 1991 240sx Engine and Drivetrain Posted: Jul, 13 2005 This engine and drivetrain were going to be a set of spares for a 1995 240sx I was preparing for ITS, but the plans changed. Now I need to make some space in...
  5. G

    Are coilovers always allowed?

    The question is: If you were to have a vehicle with independent rear suspension and the coil springs and the shocks were separate, could you then under the new rule replace the shock with a coil over and leave the original spring out? Here is the section of the GCR concerning springs and...
  6. G

    Racing Seat Poll

    What kind of seat do you have in your racecar and if you don't mind, how much was it? I don't have one yet, but I need one very soon, roll cage fabrication is about to happen and I would like to incorporate seat position into the design. Right now I am looking at either an FIA approved...
  7. G

    Good source for S14 parts?

    I had an unfortunate encounter with a curb the other day....the curb won. I am looking for a good source for suspension replacement parts, or even some spares if anyone has them. I don't have a complete list yet but I know the front control arm, possibly strut and tension rod will need...
  8. G

    Anyone in Indy?

    Looking for any members living close to Indianapolis. I am in the process of building an 85 Toyota Supra for ITS and I currently live on the southside of Indy in Greenwood. I am just about to start roll cage fab. and welcome any suggestions or lessons learned from current IT racers. It would...
  9. G

    85 Toyota Supra in ITS?

    As you can see from my username, I was planning on running a 95 240sx in ITS. However, I happened to find a 85 Supra in pretty good condition at an abandoned car auction. I figure it's my first racecar and I will probably trash it at some point, and right now the 240 is very reliable...
Back
Top