Recent content by ITR#231

  1. I

    How many of you are using a front sway-bar in your ITA CRX?

    I have been exchanging information with a handful of people on this board regarding various setups for these cars. While certain opinions seem to be pretty pervasive, I have seen a wide range of opinions regarding optimal front/rear roll stiffness. Some people prefer to increase the size of the...
  2. I

    Trying to figure out if I have a brake problem...

    When I first drove my 88 CRX Si, it wouldn't stop for sh*t and it couldn't even lock up the bald, hard street tires it came with. I had never driven a CRX before so I really didn't have a frame of reference, but it didn't feel like it was stopping like it should. Since then I have completely...
  3. I

    Tools required for replacing wheel bearings/hubs

    I have to replace a CV boot, so I figured this would be a good time to install the OPM hardened hubs and fresh wheel bearings I have laying around. I'm also going to install extended wheel studs at the same time, since I have good access to the hub. I'm looking at the helm's manual, but I'm...
  4. I

    Building the ITA CRX Si, Phase I has become a pile of parts.

    As many of you know, I started with a street stock 88 CRX Si over a month ago, and I was asking for feedback on the minimum things I should look into doing in order to put a safe, reliable car out on track (speed comes later). After receiving many suggestions (some good, some bizarre), I have...
  5. I

    Who here runs 225's on their CRX, and what does it take?

    I am changing from stock Si wheels to 7" (38mm) panasports, and I need to order a new set of tires. It has been suggested to me that many people run the 205/55/14 Kumho victoracers on all four corners, but that many people will also run a 225 up front with "some fender modification." For the...
  6. I

    Question for those running Ground Control coilovers in the C

    I just received my GC coilovers and Koni yellows, but the install instructions are downright laughable. The GC instructions are almost clear enough to follow, but from what I can tell there are a few ways to install this setup. I figured I would just ask the other ITA CRX guys about how they did...
  7. I

    Where can I find PICTURES of ITA CRXs? Lots of 'em!

    Waiting for a GCR (please come soon!) has really started to slow progress on the ITA build, and don't want to post a new question every hour as things come up. So, what would really help me out right now is pictures. I have a ton of pictures I have found of CRXs on the track, and I have found a...
  8. I

    Need recomendation for plugs, wires, and coil for ITA CRX Si

    One of the first things that needs to be replaced to smooth out the engine is the plugs and wires. There is also a chance that a new coil is necessary, but I haven't checked it out completely yet. Is there a consensus on these parts, or is this yet another source of discussion. I'm not looking...
  9. I

    You guys helped me pick her out, so you might as well meet h

    Okay, as some of you know I have been collecting information about project racecars, and I decided a little while ago on a 88-91 CRX Si for ITA and PS2. Well, after a month or so of looking, researching, test driving, etc., I finally found what I think is the perfect base for the project. It is...
  10. I

    Building the ITA CRX Si from the ground up...need input on p

    Okay, for those of you who have helped me get this far, thanks again. I have considered all of the advice that I've received, and I have decided to follow some of it, and ignore some of it. In the end, I'm looking at building an ITA CRX Si from stock, and I would like some feed back from those...
  11. I

    Could someone please break down the IT classification for 92

    I am having trouble deciphering the table on the SCCA web page, since it seems to be very incomplete. So, could someone please tell me where the following model/years are classed for IT? All 92-95 HB: CX, VX, DX, Si Thanks!!
See more
Back
Top