Recent content by ITS_Racer1

  1. I

    R180, 3:90 w/Quaife in classified

    Just posted, check it out.
  2. I

    240Z setup questions for Mr. Katman

    KT, Following the advice in your previous dissertation on setting up the 240Z, I plan to switch from "west coast" setup to "east coast" (see specifics below). Two questions please: 1) By the text book, this should tighten up the car. Is this the effect I should expect on the 'Z? 2) After going...
  3. I

    Kumho ECSTA V710 Recall

    From http://www.kumhousa.com/V710.asp " KUMHO Tire's priority is safety, and we are committed to supplying our customers with the highest quality and best performing tires that are available anywhere in the world. It is with this philosophy in mind that KUMHO is taking immediate action in...
  4. I

    240Z Quaife woes...

    Just replaced my welded diff with a Quaife ATB unit on my ITS240Z. Last weekend at Sears Point I experienced extreme wheel spin on the inside drive wheel. I was leaving 50ft strips of rubber out of T2. Quaife support suggested I am lifting the wheel off the ground (ATB needs some resistance to...
  5. I

    NASA 25hr @Thunderhill

    Great write up and links to photos and more stories: http://www.nasaproracing.com/enduro/25hour...after_rain.html
  6. I

    240Z Caster setting

    Now that I have spherical bearings on my lower control arms, I can start to add caster to my 240Z. Any thoughts on an optimal setting to start out with? Thanks, Todd
  7. I

    Spherical bushings for Z

    Does anyone know a good source for spherical bushings for the lower front control arms on the 240Z? Thanks, Todd
See more
Back
Top