Recent content by rage_racing

well the cage is about complete... will hopefully be welded in next week... as far as the door bars go I know that on the drivers side it can extend into the door but what about the passenger side can I make it identical or does the passenger side have to stay completely intact? just double...

I have been able to locate a header for every honda engine butmy 1986 1.8L carb engine. does anyone have suggestions on what I can do besides stick with the stock manifold? will something off one of the newer 1.8L work I have found them for the 88-91( i believe) Acura 1.8L HelpI do not wanna...

I am in the process of yanking the AC and emissions off my car and honda being the vacuum nightmare that it is any suggestions on what I should do ie. EGR, O2 sensor,Air Jets, charcoal canister etc etc etc.. I want to eliminate all the allowed emmisions stuff but dont want to sacrifice...

okay before you say read your gcr I am waiting for it to get here so do I understand this right A. Exhaust-- no cat needed, o2 sensor or any of that as long as it meets the decibal requirement B. Air intake-- provided it stays inside the compartment or uses the stock cold air location mods can...

well I think I just solved my frustrations with the 86 prelude hopefully within the next hour I am gonna go pick up an 88 which does have readily available parts unlike the 86!!!!!!!!

now its in the right section...I have been looking everywhere for suspension for my prelude which falls in 83-87 parts category and the only shock/strut I can find is the KYB Gr2 any suggestions on the best way to get a good suspension for this carit doesnt seem to be interchangeable with any...

I have been looking everywhere for suspension for my prelude which falls in 83-87 parts category and the only shock/strut I can find is the KYB Gr2 any suggestions on the best way to get a good suspension for this carit doesnt seem to be interchangeable with any other honda or acura

well as I have been on the rampage of tearing down a car to build which is coming along quite well I might add.. the down side was the Bit@#ing from my other half..well I sorta solved that problem today when I had her in the garage wrenching with me..(of course the statement you are just to...

okay how much reinforcement is allowed in floor boards? I have the interior out and much to my surprise only 2 spots of rust unfortunately its right where the main hoop welds in at..

question for all you gurus I found the sourse of my ignition problem fried computer can I use an aftermarket or do I have to remain with the stock type? what I was looking at was the v-force power control module which is like 100.00 less than OEM computer any suggestions

are there any 1.8l engine wizards here I have so far replaced the distributer cap, rotor , plugs and wires and still have only 2 running cylinders any ideas!!!!

newbie racer looking to meet up with racers in this area

I am looking for an IT car to build for next year and have never done this before so I have some questions A. type of car I am looking at is a 93 acura integra a 92 elclipse 90 chevy beretta and I have an 86 prelude already in the back of the garage not sure which of these would be the best to...