Recent content by Silkworm

Hey guys, I need to replace the AN fitting on the oil line connecting the engine front cover to the top of the oil cooler. Any idea what size that fitting is? PaulC

Hey guys, Anyone know of a company that can make single patches with your Name/blood type/allergies? All the custom patch makers are 100pc minimum orders that I found. PaulC

I lost the sheet that came with these struts/shocks and haven't looked at the settings since earlier last year, and for the life of me I can't remember if CW is stiffer or CCW. PaulC 88 PS1/ITS RX-7

Overall weight 2459, 1/4" tank of gas, all fluids, race ready setup, no driver With driver, 2771 (Ok, yes, I'm a lard ass! ) That puts me 90lbs over minimum weight, and if my dieting works out, I should be good to go (I doubt I'm ever going to be below 220 weight wise) First pass, eyeballed...

My head is spinning, I'm not good at electronics or wiring, so please help me figure out what I need to do here. Reference this graphic that I found. http://www.ssdiv.com/killsw.gif Ok, so the battery wire goes to one of the two big poles. A wire then goes from the other big pole down to the...

Let's see how this sucker goes Feels very strong, brakes great, sounds good, rolls a lot (no swaybar), I think we're in good shape. PaulC

Hi folks, Well, the jumping tachometer problem I've been having (tach would work intermittently, only under acceleration) is resolved, just bolted down the trailing coil (had it loose for cluster master cylinder bleeding).. I guess it grounds at the front two studs. Now my sequential...

I have no affliation with Tire rack, but I was up there looking for Kosei K1s, and noticed that they dropped the SSR Comps from 299 to 239 for 15x7s.. Still not cheap enough for me to consider them, but I know some of you like those wheels, and at that price, you'll probably like them even...

Is there a vent on the rear differential housing? I don't remember seeing one, but maybe I missed it, I don't see it in the shop manuals.. PauLC

Hey guys, Welp, the RX-7 is now officially a running motor. However, I can't get the bastard to idle. Tach doesn't work, not sure what the RPMs are at, but just a hair bit of pressure on the throttle and the engine will remain steady at that RPM, but if I back all the way out of the gas, it's...

Higher the better? Specific pressure? Went to a griffin, so I don't know the stock specs (wonder if it's in the FSM, don't have that handy at the moment) PaulC 88 PS1/ITS RX-7

I'm removing stock guages, and the speedometer cable is going with them. Can I just put a vinyl cap over the fitting on the trans? Is trans fluid going to be moving through that fitting (doubt it)? PaulC ------------------

How'd you guys do that? I tried cutting it, wore out 3 jigsaw blades without making much of a dent.. high speed cutter on the dremel doesn't touch it either. I thought about putting a thin piece of aluminum in there and sandwiching it between the lock and the steering shaft, there's not a...

LOL.. Twin .50s would help with some of the IT fields here PaulC [This message has been edited by Silkworm (edited March 12, 2002).]

Looks like my email filter killed your message, please resend, I turned it off. PaulC ------------------