Recent content by terry

Looking for opinions on fuel pumps, fuel lines, and any other info around mounting a cell in a 240Z Terry

Just turned 50 and have permission to spend time and money for a driving school. I am not interested in driving open wheel cars, too short, fat, and wide to fit in one. Interested in others suggestions and experiences. Will probubly be racing a 240z in ITS or EP next year. Thanks Terry

I'm thinking about buying a clutch limited slip for my 240z. Seller states the break away is set at 45lbs. Is 45 lbs the way to go or is there an advantages of setting the break away higher or lower? Thanks Terry

I'm replacing the stub axels and bearings on my 240z and would like to use 1/2 x 20 studs. Does anyone make a stud to fit without modifing the the holes in the stub axel?

I replaced my chattering clutch with a Center Force II disc and plate. After 5 to 6 laps it becomes hard to shift and now will not go into gear. I replaced the master,slave, and the hydrolic hose. Checked the collar length and replaced the bearing. Bled the system again. Adjusted the rod on...

I changed to the eastside. (heavier springs on front) Dropped 1/2 second with the car pushing and having to short shift due to a chattering clutch. If I reved above 62-6300 from 3rd to 4th gear I had to back off the throttle to stop the chattering. I also put aluminum sway bar mounts on the...

What tires work for you?

Starting my second year of racing and have always wanted to race at some California tracks. I think I could get my wife to come if I would add a couple days after the race and make it a short vacation. I have a conference license. Would also be interested in vintage races also. Any ideas?

Looking for opinions on a cheaper tire to use to get seat time, ie; toyo or kumho 225-15. I have an its 240 with a over weight driver. Thanks

Looking for a R180 with a 3:7 for a 240Z Tahnks Terry

I'm going to put heavier springs in my 240z. I have recieved differing opinions on which end of the Z I should place the heavier springs. Since I'm new to racing I do not have a clue. One of the tracks I race on has high speed bumps and the others are fairly smooth. HELP!!! P.S. Anyone have...

Attended Team Contental driving school this past Sunday at Porland. Great group of people. learned a lot. Car and driver need work. Last 2 sessions had little to almost no brakes. Experience was great.

Anyone near the Salem-Portland area know of a 5sp Z-car transmission for sale?

Any ideas on spring rates for a 280-z. Also camber, toe, & caster

Wear is the best place to buy brake drums for a 280z?