Search results

I know this is the IT web site, but I have a Nissan question concerning the engines allowed for the 84-89 Z31 in GT2... Looking at the list of engines on page 262 of the 2007 GCR, I notice the obvious 2960cc V6 that comes stock with these cars. But I also notice other eligible engines include a...

I am looking for a source for longer wheels studs for my 1986 300ZX. Any ideas? One racer suggested 1/2 inch studs from Racer Wholesale, but that would require drilling out the holes and welding the studs on the backside to keep them from spinning. I also need a factory manual for the car. I've...

Concerning my 300ZX ITS that had clean plugs on 2 - 4 - 6 and fouled plugs on 1 - 3 - 5... I looked at a ton of stuff to see what I could see and for some reason decided to open up the distributor to look at it. I found that the etched mylar piece no longer had a flat side on the center, it was...

Because I helped my brother-in-law get ready for the Runoffs in FF, I am just now trying to diagnose a problem in my ITS 1986 300ZX... At the regional race at Texas Motor Speedway in September, the car ran ok during qualifying -- it would seem to miss occasionally, like it was flooded then it...

Because I helped my brother-in-law get ready for the Runoffs in FF, I am just now trying to diagnose a problem in my ITS 1986 Nissan 300ZX... At the regional race at Texas Motor Speedway in September, the car ran ok during qualifying -- it would seem to miss occasionally, like it was flooded...

Because I helped my brother-in-law get ready for the Runoffs in FF, I am just now trying to diagnose a problem in my ITS 1986 300ZX... At the regional race at Texas Motor Speedway in September, the car ran ok during qualifying -- it would seem to miss occasionally, like it was flooded then it...

I just installed my rebuilt engine in my 1986 300ZX ITS car and took it out to the local dragstrip to check everything out. Warmed it most of the way, the first run was great, but on the return road I could not keep the engine running below about 2500 rpm. I staged again, but had to keep it...

I just installed my rebuilt engine in my 1986 300ZX and took it out to the local dragstrip to check everything out. First run was great, but on the return road I could not keep the engine running below about 2500 rpm. I staged again, but had to keep it running above 2500. Ran it through a 2nd...