2007 passinger side door bar rule.

flaboy

flaboy

New member
My question is: does the passinger side need to be like the drivers side with the bars going into the door?

I already have a bar on top and then a diangnal bar running from the front bar to the bar running behind the seat area.

is this all i need?

Please advise.


Thanks

Tim
ITC rabbit
CFR
 
They need not be the same; just two bars per side.

The advantage given those who want to take a bar into the door cavity--on either or both sides--is you get to remove the glass in the door in which the bar intrudes.

If you do not need the weight break, there is no need to change your set-up.

Cheers.
 
Based on your description, you're fine like you are.

Sounds like the perfect setup to run some 1"x.025 Nascar bar to gut the door. :wacko:

I applaud the new rule for allowing other size tube for non required bars, but the rule needs to be looked at from a safety angle. Too big of a loop hole IMO.
 
Sounds like the perfect setup to run some 1"x.025 Nascar bar to gut the door. :wacko:[/b]
Click to expand...

I thought of the same thing...HOWEVER, once you gut the door the "NASCAR bar" becomes a required tube, thus subject to the minimum tubing size... - GA
 
You must log in or register to reply here.
Back
Top