RX7 guys help with dash / cage ??????

R

ROBTRLRDR

New member
hi guys
i was wanting to know how you cut or modified your dash / console for the cage and the cross member. the tube that would pass through the console area.
i tried to cut as little as possible at the sides of the dash. but the center console is so brittle it just cracks when i move it a bit.
88 na , post some pics if you have them.
thanks
robert
 
Sorry Robert, but my cage goes through my dash. Although the pics on page 2 of my web page, http://home.mindspring.com/~twire , don't show the dash installed, I have since fit the dash and I only cut it in 3 places. The two front down tubes and the end of the dash where the X bar goes.

------------------
Chris Wire
Team Wire Racing
ITS Mazda RX7 #35
[email protected]
 
Robert, I race a Spec-7 there for I can not do the dash cross tube. On this site if you were to click on Tech Center & then click on Tech Photos you will find a bunch of photos of a CRX complete roll cage/dash bar. The dash will show a horizontal tube with one diagonal from near the center going to each side tube. Upon doing something for the first time it will take considerable thinking/planning & trial.

------------------
Have Fun ;)
David Dewhurst
CenDiv Milwaukee Region
Spec-7 #14
 
Frank, when I click on your address I get a ERROR 404. No site.........
frown.gif
 
THANKS GUYS
the only way i could to the balz site was to copy and paste the address and delete the "/racing". then the site loaded ok.
thanks
robert
 
It's a 1st gen, but there are a few pics on our website of our cage. Click the pic below then look for the RX7 link on the sidebar.

------------------
Scott
It's not what you build...
it's how you build it

replica2small.jpg

E-mail me for deals on
Lightweight Replica Blocks!
 
You must log in or register to reply here.
Back
Top